Simple Chocolate Coating

INGREDIENTS

INSTRUCTIONS

* (do not use butter, margarine or oil)
Cover tray with wax paper. In medium heat-proof bowl, place chocolate
chips and shortening. In separate large heat-proof bowl, put very warm
water (100 to 110 F.) to 1-inch depth. Carefully place bowl with
chocolate into bowl with water; water should come halfway up side of
chocolate bowl. With dry rubber scraper, stir chocolate and shortening
CONSTANTLY, until chocolate and shortening are melted and mixture is
smooth. Do NOT get water in bowl with chocolate.* If water cools,
replace it with very warm water as directed above. Remove chocolate bowl
from inside water bowl. With fork, one at a time, dip chilled centers
into chocolate mixture; gently tap fork on edge of bowl to remove excess
chocolate.** Invert coated center on prepared tray; swirl small amount
of melted chocolate on top to cover fork marks; let stand until firm.
Store candies loosely covered in cool, dry place. Coating for 3 to 4
dozen centers.
* If water or moisture gets into chocolate, it can seize and tighten. As
an emergency measure, ONLY, stir in additional shortening, 1/2
teaspoonful at a time, just until chocolate is fluid again.
** If chocolate mixture cools below 84 F, return bowl with chocolate
into bowl with warm water. Chocolate is best for coating between 84 and
88    F.
CHOCOLATE CANDY IN MOLDS: Melt chocolate with shortening as directed
above; remove bowl from inside water bowl. Spoon chocolate mixture into
plastic candy molds; let stand until firm. Invert molds over prepared
tray; tap candy from molds onto tray. Store as directed above. About 4
dozen 1x1-1/2 inch candies.
Hershey's is a registered trademark of Hershey Foods Corporation.
Recipe may be reprinted courtesy of the Hershey Kitchens.
Meal-Master format by Karen Mintzias
File ftp://ftp.idiscover.co.uk/pub/food/mealmaster/recipes/hershey3.zip

A Message from our Provider:

“Life Has Many Choices. Eternity Has Two.”